Nortel DMS-100 Manual page 91

2-44 System level recovery procedures
Performing a warm restart
15
At the MAP terminal
16
17
18
297-8021-545 Standard 14.02 May 2001
(continued)
Monitor the CM reset terminal for the active CPU to determine if the switch
restarted.
Note: When the switch restarts, alphanumeric addresses appear in the
status bar for the reset terminal. When the switch restarts, A1 flashes in
the status bar.
If A1
flashes
does not flash after five minutes
WARNING
Extended service interruption
The exact login procedure can vary, according to your office
configuration. If you need additional help, contact the next
level of support.
Determine if you must log in.
Note: The message Please Login indicates that you must log in.
Depending on your office parameters, the system logs you in
automatically.
Example of a MAP response:
Please Login.
If
you must log in
the system logs you in automati-
cally
Press the Break key.
MAP response:
?
To log in to the MAP terminal, type
>LOGIN
and press the Enter key.
MAP response:
Do
step 16
step 29
Do
step 17
step 21