Nortel DMS-100 Manual page 277

4-70 Recovery procedures for individual devices and services
Recovering AMA data without DIRP block numbers
46
47
48
49
50
51
297-8021-545 Standard 14.02 May 2001
To continue to the next field, press the Enter key.
Note: The * is a wild card. The * matches any variable.
To fill in the TERM NUMBER field, use the terminating number value that you
obtained in step 11. If the value contains any zeros, define the field with all
the zeros included.
Example input:
>8385792* or 8385792C
To continue to the next field, press the Enter key.
Note: The * is a wild card. The * matches any variable.
To fill in the CONNECT TIME field on the screen, use the connect time value
that you obtained in step 11. If the value contains zeros, define the field with
all the zeros included.
Example input:
>0000152* or 0000152C
Press the Enter key.
Note: The * is a wild card. The * matches any variable.
To stop the movement of prompts to the next field, type
>$
and press the Enter key.
To check the information you entered in the filter field in steps 43 to 47, type
>FILTER DISPLAY ALL
and press the Enter key.
This command displays a record that contains all the fields that you defined.
Example of a MAP display:
*HEX ID = AA STRUCT CODE:00700*
SENSOR TYPE: **** SENSOR ID: ******** REC OFC TYPE: ****
REC OFC ID: ******** DATE: ****** TIMING IND: ******
STUDY IND: ******** ANSWER: ** SERV OBSERVED: **
OPER ACTION: ** SERV FEAT: **** ORIG NPA; 602C
ORIG NO: 9422640C OVERSEAS IND: **
TERM NO: 8385792C TIME: ******** ELAPSED TIME: **********
IC/INC PREFIX: ****** CC DATE: ****** CC TIME: 0000152C
ELAPSED CC: ********** IC/INC EVENT: **** TRK ROUTING: **
DIALING: ** ANI: **
To enable the filter function, type
>FILTER ENABLE
and press the Enter key.
To filter through the parallel file, type
>DUMP CALL DETAILS
and press the Enter key.
(continued)
CALL TYPE:****
TERM NPA; 00602C