Nortel DMS-100 Manual page 108

Recovering from a dead system in a SuperNode switch
At the CM reset terminal for the INACTIVE CPU
36 To release the jam on the inactive CPU, type
>\RELEASE
and press the Enter key
RTIF response:
At the CM reset terminal for the ACTIVE CPU
37 Monitor the CM reset terminal for the active CPU to determine if the switch
booted.
At the CM reset terminal for the INACTIVE CPU
38 To jam the inactive CPU, type
>\JAM
and press the Enter key.
RTIF response:
Please confirm: (YES/NO)
39 To confirm the command, type
>YES
and press the Enter key.
RTIF response:
JAM DONE
At the CM reset terminal for the ACTIVE CPU
40 To override the active CPU, type
>\OVERRIDE
and press the Enter key.
RTIF response:
TEMP. RESET/JAM ENABLE
JAM
JAM RELEASE DONE
Note: When the switch boots, the reset terminal displays the response
"Booting" followed by various diagnostic messages. The status bar
displays alphanumeric addresses. When the switch boot completes, A1
flashes in the status bar.
If A1
flashes
does not flash after 15 min
DMS-100 Family NA100 Recovery Procedures LET0015 and up
System level recovery procedures
Do
step 44
step 38
2-61
(continued)