Nortel DMS-100 Manual page 246

Recovery procedures for individual devices and services
Note: Repeat this step until you return to service all positions that apply.
If RTS
passes
fails
At the MAP display:
7 To access the TTP level, type:
>MAPCI;MTC;TRKS;TTP
and press the Enter key.
8 To post the MP position trunk that applies, type:
>POST T TOPSPOS n
and press the Enter key.
where
n
is the MP position number (0, 1, 2, or 3)
9 Note the status of the trunk circuits.
If the trunk status
is MB
is SB
10 To busy the posted trunk, type:
>BSY
and press the Enter key.
11
To return the posted trunk to service, type:
>RTS
DMS-100 Family NA100 Recovery Procedures LET0015 and up
MP position (standalone)
Do
step 7
step 15
Do
step 11
step 10
CAUTION
Trunk goes system busy
Do not RTS the TOPSPOS trunk until the MP position is
downloaded (VDU displays Link problems encountered).
The trunk goes system busy if the trunk is RTSed before Link
problems encountered appears on the VDU.
recovery
(continued)
4-39