Nortel DMS-100 Manual page 38

Hide thumbs Also See for DMS-100:

Table of Contents

The preceding ﬁgure shows a MAP display during the period that the

DMS-core loads software again into a DTC. The load process reloads the

software after the memory has passed the ROM test. The size of the loaded

software increases from 0 kbyte to the ﬁnal size in 13-kbyte increments. The

display value updates with each increment. The percent loaded ﬁgure

indicates the loading progress. The percentage is based on the total size of the

load. The loading time for a PM varies depending on the PM type, its load size,

and the CPU resources available.

Figure 1-15 MAP display of the load process that runs a new software load on

Unit1: Inact

The preceding ﬁgure shows a MAP display during the period that the load

process runs a new DTC software load. After the RAM is loaded, the load

process signals the DTC to run the new software load. This begins the

initialization of the modules in the DTC. This display lasts for less than 5 s,

then the DTC begins initialization.

DMS-100 Family NA100 Recovery Procedures LET0015 and up

System recovery controller 1-25

CSide0,PSide0

Chapters

Table of Contents