Nortel DMS-100 Manual page 56

addresses appear in the status bar. When the switch boot finishes, A1
flashes in the status bar.
If A1
flashes
does not flash after 15 min
21 Determine the boot device (the most recent valid image).
If the boot device is from an
SLM tape
SLM disk
22
Make sure that the SLM tape cartridge that contains the most recent image
file is in the tape drive.
DMS-100 Family NA100 Recovery Procedures LET0015 and up
System level recovery procedures
Booting a DMS switch
Do
step 37
Repeat step 6, or contact your
next level of support.
Do
step 22
step 30
DANGER
BOOT command
A CPU mismatch occurs if you use the BOOT command
when the CPUs are InSync. Mismatch handling and
mismatch recovery can change the state of one of both CPUs.
For example, the active CPU can reset the mate CPU during
mismatch handling or recovering. Any in-progress
commands such as BOOT terminate, as a result.
2-9
(continued)