Nortel DMS-100 Manual page 387

5-38 Emergency power conservation recovery procedures
Emergency power conservation measures
Restoring the LGCs, LTCs, and DTCs to duplex operation
21
22
23
24
25
26
27
297-8021-545 Standard 14.02 May 2001
plane_no
is the network plane (0 or 1)
link_no
is the network link number
Repeat steps 19 and 20 until all links between the manual busy XPM unit and
network return to service. Go to step 29.
Determine the speech link numbers associated with the manual busy XPM
unit. Even numbered speech links associate with unit 0. Odd numbered
speech links associate with unit 1.
Note: Speech links 0, 2, 4 and 6 associate with XPM unit 0 in the ENET
example response in step 14. Speech links 1, 3, 5, and 7 associate with
XPM unit 1. The speech links associated with XPM unit 1 are manual busy.
Record the ENET plane number, shelf number, card number, and network link
number associated with the speech link. Perform this procedure for each
speech link recorded in step 22.
Note: An ENET example response appears in step 14. In this example,
speech link 3 associates with ENET plane 1, shelf 0, card 24, and network
link number 01.
To access the NET level of the MAP display, type
>NET
and press the Enter key.
To access the MAP display for the associated ENET card of the first speech
link, type
>SHELF shelf_no;
and press the Enter key.
where
shelf_no
is the ENET shelf number
card_no
is the ENET card number
To return the first link recorded in step 22 to service, type
>RTS plane_no
and press the Enter key.
where
plane_no
is the ENET plane number, recorded in step 23
link_no
is the network link number, recorded in step 23
To remove the deload status from the ENET card, type
>DELOAD plane_no
and press the Enter key.
CARD card_no
LINK link_no
CLEAR
(continued)