Recovering From A Dead System In A Supernode Se Switch - Nortel DMS-100 Manual

Hide thumbs Also See for DMS-100:

Table of Contents

2-86 System level recovery procedures

Recovering from a dead system in a SuperNode SE switch

Use this procedure to recover a dead system. A DMS SuperNode SE switch is

dead if the whole switch is without power. Loss or interruption of A and B dc

power feeds to the power distribution centers (PDC) causes a dead switch.

The following ﬂowchart provides an overview of the procedure. Use the

instructions in the step-action procedure that follows the ﬂowchart to perform

the recovery task.

297-8021-545 Standard 14.02 May 2001

Table of Contents