Nortel DMS-100 Manual page 161

2-114 System level recovery procedures
Recovering from a dead system in a SuperNode SE switch
167
168
169
297-8021-545 Standard 14.02 May 2001
SSNAME SSNO SEQNO ROTATES POOLNO PARLPOOL EMERGENCY
AMA 0 1
REGULAR
FILE(S) STATE VOLUME
ACTIVE NONE
STANDBY1 NONE
PARALLEL
FILE STATE VOLUME
NONE
REGULAR VOLUME(S)
VOL# VOLNAME STATE
REGULAR SPACE
If
volumes are not allocated, as indicated
by the word NONE under the STATE
header on the MAP display
a volume is IN ERROR, as indicated un-
der the REGULAR VOLUME(S) header
on the MAP display
all volumes are READY, as indicated un-
der the REGULAR VOLUME(S) header
on the MAP
To reset any volumes that are IN ERROR, type
>RSETVOL vol_name
and press the Enter key.
where
vol_name
is the name of the volume to reset
If the RSETVOL command
passed
failed
Perform the procedure Allocating recording volumes in the DIRP utility in
Routine Maintenance Procedures . Complete the procedure and return to this
point.
To determine the state of the DLOG recording volumes, type
>QUERY DLOG ALL
6 9 62 ***YES***
RECCOUNT BLOCK E V V_B VLID FNUM FRN#
BLOCK E V V_B VLID FNUM FRN#
IOC CARD VOL FSEG ROOM VLID FILES
Do
step 168
step 167
step 169
Do
step 169
step 193
(continued)