Power Door Locks; Keyless Enter 'N Go; Passive Entry - Dodge DURANGO 2022 Owner's Manual

WARNING!
 Do not leave the key fob in or near the vehicle, or in
a location accessible to children, and do not leave
the ignition of a vehicle equipped with
Keyless Enter 'n Go™ in the ACC or ON/RUN position.
A child could operate power windows, other controls,
or move the vehicle.
 When leaving the vehicle, always make sure the
keyless ignition node is in the OFF position, remove
the key fob from the vehicle and lock the vehicle.
Unsupervised use of the vehicle equipment may
cause severe person injuries and death.
P D L
OWER OOR OCKS
The power door lock switches are located on each front
door panel. Push the switch to lock or unlock the doors
and liftgate.
Power Door Lock Switches
If the lock knob is down when the door is closed, the door
will lock. Make sure the key fob is not inside the vehicle
before closing the door.
NOTE:
If the key fob is located next to a mobile phone, laptop, or
other electronic device, the wireless signal may get
blocked, and the driver's door may not unlock automati-
cally.
If the door lock switch is pushed while the ignition is in the
ACC or ON/RUN position, and the driver's door is open, the
doors will not lock.
If a rear door is locked, it cannot be opened from inside
the vehicle without first unlocking the door. The door may
be unlocked manually by raising the lock knob.
K E ' G ™ —
EYLESS NTER N O
P E
ASSIVE NTRY
The Passive Entry system is an enhancement to the
vehicle's Remote Keyless Entry (RKE) system and a
feature of Keyless Enter 'n Go™ — Passive Entry. This
feature allows you to lock and unlock the vehicle's door(s)
without having to push the key fob lock or unlock buttons.
GETTING TO KNOW YOUR VEHICLE
NOTE:
 Passive Entry may be programmed on/off within Ucon-
nect Settings page 135.
Ú
 The key fob may not be detected by the vehicle Passive
Entry system if it is located next to a mobile phone,
laptop or other electronic device; these devices may
block the key fob's wireless signal and prevent the
passive entry handle from locking/unlocking the
vehicle.
 Passive Entry Unlock initiates illuminated approach
(low beams, license plate lamp, position lamps) for
whichever duration is set between 0, 30, 60 or 90
seconds. Passive Entry Unlock also initiates two
flashes of the turn signal lamps.
 If wearing gloves, or if it has been raining/snowing on
the Passive Entry door handle, the unlock sensitivity
can be affected, resulting in a slower response time.
 If the vehicle is unlocked by Passive Entry and no door
is opened within 60 seconds, the vehicle will relock and
will arm the Vehicle Security system (if equipped).
21
2