Table of Contents
Advertisement
Ramp Load
Ramp Load
suddenly. It is more dangerous, when the plug for air stopper blows off from the air
fitting.
Figure H-6
Plug the Air Fitting using Air Stopper Assembly
The LED on it shows the status of the ramp loading mechanism. Assignment of the LED is
as follows.
Table H-2
LED Assignment
Power
Tilt
Ramp
Error
Ramp Cylinder Installation
Install the ramp cylinder assembly to the ramp rail assembly.
For UP face, tighten the two screws with 2.0 mm hex key to install the ramp cylinder
assembly to the ramp rail assembly as shown in Figure H-7.
For DOWN face, tighten the two screws with 2.0 mm hex key to install the ramp cylinder
assembly to the ramp rail assembly as shown in Figure H-8.
436
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
LED
When DC 24V is supplied from the power supply unit, LED is
illuminated.
When switch is set to "Tilt", LED is illuminated.
When switch is set to "Ramp", LED is illuminated.
This LED is illuminated under the following situation.
•
The system performs the Ramp In, But the ramp is still in Ramp Out
position.
•
The system performs the Ramp out, But the ramp is still in Ramp In
position.
Description
Appendix H
Advertisement
Table of Contents
