Table of Contents
Advertisement
VEE Measurement Program Operation
Measurement
Figure 3-57
Fast Micro Track Menu
2. Set the parameters, click on each button to enter a new value.
Channel Bit Rate
Write Current
Sense Current
Data Pattern
Track #
Side Erase Position
Side Erase Mode
Offset Start
Offset Stop
110
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Specifies the speed at which data bits are
written on the media per second [bps].
Specifies the current applied to the write head.
Specifies the current applied to the read head.
Specifies the data pattern to be written on the
test track. To set the data pattern, click on the
[Configuration] > [Setup] > [Pattern Config]
buttons to open the data pattern menu.
Specifies the track number to be tested.
Specifies the position to erase the side of the
track in creating a micro track.
Specifies the erase method. When "Erase
Both" is selected, both sides of the track will
be erased. When "Erase Single Side" is
selected, only one side of the track will be
erased. See
"hpe5022_measureMicroTracProfile"
function.
Specifies the starting point of the head offset
in measuring the TAA track profile.
Specifies the stopping point of the head offset
in measuring the TAA track profile.
Chapter 3
Advertisement
Table of Contents
