Table of Contents
Advertisement
1.
Click on [Narrow Band TAA] to open the Narrow Band TAA menu.
Figure 3-42
[Narrow Band TAA] Menu
NOTE
For Stability measurement of Narrow Band TAA, tracks are unsectored.
2. Set the parameters, click on each button to enter a new value.
Skip Erase & Write
Channel Bit Rate
Write Current
Sense Current
Data Pattern
# of Counts
Track#
Write Time
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VEE Measurement Program Operation
Selects the type of measurement sequence.
Erease and write sequences are not done when
this is checked.
Specifies the speed at which data bits are
written on the media per second [bps].
Specifies the current applied to the write head.
Specifies the current applied to the read head.
Specifies the data pattern to be written on the
test track. To set the data pattern, click on the
[Configuration] > [Setup] > [Pattern Config]
buttons to open the data pattern menu.
Specifies the number of measurement counts.
where, count = revolution x segment
Specifies the track number to be tested.
Specifies the time to write the data. Minimum
value is 1[µsec] and maximum value is
10[msec]. Refer to
"hpe5022_measureAbsStability" function of
Measurement
89
Advertisement
Table of Contents
