Table of Contents
Advertisement
height. The "R" reading can be calculated from the equations below.
NOTE
For standard disk thickness (0.8-mm), the micrometer reads direct Z-height (i.e, R=Z). For
non-standard disk thickness (e.g, 1.0-mm and others), the user must compensate the "R"
value by using the equations below.
In case of mm :
In case of inch :
Table C-2
11. Before attaching the cassette to be adjusted, slightly loosen the pin and the hexagonal
screws located on top of the cassette as shown in Figure C-6 (i.e, magnified view). To
adjust the pin screw use a 0.89-mm or 0.035" hex screwdriver, to adjust the hexagonal
screw use a 1.5-mm hex screwdriver.
NOTE
When working on step 10 DO NOT ATTACH the cassette on the Z-height adjustment tool
yet.
Appendix C
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(
)
R
=
Ð
Z
Ð
T
Ð
0.8
R = Read setting (mm)
Z = Z-height (mm)
T = disk thickness (mm)
(
R
=
Ð
Z
Ð
T
Ð
0.0315
R = Read setting (inch)
Z = Z-height (inch)
T = disk thickness (inch)
Example in setting the Z-height
Disk Thickness (T)
0.8 mm (standard)
1.0 mm (non-standard)
Cassette and Z-Height Adjustment
Z-height Adjustment for E5029C/D Cassettes
)
Z-height (Z)
0.65 mm
0.65 mm
Read setting (R)
-0.65 mm
-0.85 mm
395
Advertisement
Table of Contents
