Table of Contents
Advertisement
Error Messages on PC Monitor Display
Error Code
hpe5022_ERROR_NSUP_SENS_CURR_POL
hpe5022_ERROR_OPEN
hpe5022_ERROR_OPT_FAIL
hpe5022_ERROR_OVERFLOW
hpe5022_ERROR_PARAMETER_SET_FAILED
hpe5022_ERROR_PEAK_NOT_FOUND
hpe5022_ERROR_PES_DATA
hpe5022_ERROR_PLL_UNLOCK
hpe5022_ERROR_QUEUE_OVERFLOW
hpe5022_ERROR_RESAMP_FAILED
hpe5022_ERROR_REVISION
Appendix B
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Error Messages on PC Monitor Display
Description
The head does not support
the reverse polarity on a
stability measurement. Set
the polarity at normal.
Unable to open some
components in
initialization. (instruments
and the spinstand).
The optimization is failed.
An overflow is detected in
the parametric module.
Perform the auto
configuration (input range)
or Check if the setting
parameter is correct.
The acquisition parameters
are invalid for an
oscilloscope. Reduce the
value of the over sampling
rate, the wave averaging
factor or the channel bit
rate.
The peak can't be found in
the track profile result.
Check if the track profile is
performed properly.
Effective position error
signal data can not be
measured.
The PLL is unlocked.
Check if the parameter
setting is correct.
Error queue overflows.
The waveform resampling
has failed.
The revision between
system software and
module firmware in not
same. Reinstall E5023A
software.
Error Messages
385
Advertisement
Table of Contents
