Table of Contents
Advertisement
VEE Measurement Program Operation
Measurement
Adjacent Offs. Stop
Adjacent Offs. NOP
Adjacent Offs. Step
3. Click on the [747 Setup] button to set the parameters before you proceed to
measurement.
[747] > [747 Setup]
Range
NOP
188
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
can be set from 0[µm] min. to 6[µm] max.
Specifies the stopping point of the adjacent
track offset. This point is defined as the
distance in [µm] between the track center and
the adjacent track. The adjacent offset range
can be set from 0[µm] min. to 6[µm] max.
Specifies the number of points to be measured
between 'Adjacent Offs.Start' and 'Adjacent
Offs. Stop'. If you set this parameter with
[Adjacent Offs.Start] and [Adjacent Offs.
Stop], then [Adjacent Offs.Step] will be
computed and updated automatically. The
NOP can be set from 1 min. to 201 max.
Specifies the step by which the adjacent track
position is decremented to measure and plot
the 747 curve. If you set this parameter with
[Adjacent Offs. Start] and [Adjacent Offs.
Stop], [Adjacent Offs. NOP] will be computed
and updated automatically.
Specifies the range by which to build the track
profile. The range can be set from 0 min. to
6[µm] max.
Specifies the number of points or increments
to build the track profile within the specified
Chapter 3
Advertisement
Table of Contents
