Table of Contents
Advertisement
VEE Measurement Program Operation
Measurement
3. Click on the [Erase] button to erase a whole specified area.
4. Click on the [Write] button to write a track at the specified start position. A data
5. Click on the [Unload] button to unload a head, then replace the HGA. If necessary, the
6. Click on the [Search] button to find a track. After finding a track, the head position is
NOTE
A value of the read/write offset result does not affect a read offset in the setup menu.
Figure 3-124
Track Search Result
204
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Search Pitch
pattern, channel bit rate and write current can be set in [More Config.].
HGA dimension and cassette part number should be set by clicking on the [Cassette
Parameter].
Even when a head is unloaded, the spindle is still running to avoid a media slipping.
changed where it is by actuating X-Y stages. Then, a track profile measurement is
made. Its result (profile curve and read/write offset) is displayed on the left of the
screen. The setting of the track profile measurement can be specified by clicking on the
[Profile Setup].
Specifies a pitch of the search a track.
Chapter 3
Advertisement
Table of Contents
