Table of Contents
Advertisement
Cassette and Z-Height Adjustment
Battery Replacement Procedure for Micrometer and Z-height Tool
Figure C-11
Removing the pc board
7. Remove the cable tie with a cutting plier.
8. Remove the lithium battery and replace it with a new one. The battery is not soldered to
NOTE
Observe correct polarities when you replace the battery.
9. Wrap the battery with a cable tie. (cable tie part number: 1400-0249).
10. Replace the pc board to its original location as in Figure C-11.
11. Screw 3 hexagonal round screws using 2-mm hex screwdriver.
12. Replace the bottom cover into the Z-height tool housing.
13. Screw 6 hexagonal flat screws using 2-mm hex screwdriver.
14. Replace the micrometer into the slot of the Z-height tool.
15. Tighten up the hexagonal screw as shown in Figure C-9 to fix the micrometer using
400
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
the pc board, it is connected to the pc board through the battery holder. The battery
rating is 3V, 2/3A. (Refer to Table C-4).
2.5-mm hex screwdriver.
Appendix C
Advertisement
Table of Contents
