Table of Contents
Advertisement
Head Load Frame, head loading configuration is set by the parameters below.
Load Type
Load Radius
Load Mode
Initial Track #
NOTE
When the [***] is displayed, see the advanced head load configuration menu.
Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Specifies the type of loading as Normal, Ramp
and Tilt. The Ramp allows you to use the ramp
load wich is available with the
E5010C/E5013A Option 320. The Tilt allows
you to use the tilt load which is available with
the E5010C/E5013A Option 310.
This parameter is defined as the radius of the
head at initial loading. This is no the same as
initial radius.
Specifies the type of loading as either
Dynamic or Static Loading. Dynamic is a type
of loading where the spindle rotation is
continuous when the head is loaded and/or
unloaded. Static is a type of loading where the
spindle rotation stops during loading and
unloading of the head, thus resetting the
rotation is required.
This parameter specifies the initial track
where the head moves initially right after
loading.
Configuration
Configuration
231
Advertisement
Table of Contents
