Table of Contents
Advertisement
VEE Measurement Program Operation
Measurement
[BER] Menu
Measurement
1. Click on [BER] button to open the BER Test menu.
Procedure
Figure 3-108
Ber Menu
2.
170
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Exec. Optimize
Abort
Track Offset Compensation
Set the parameters, click on each button to enter a new value.
Sector Data Log Mode
Raw Data Log Mode
Optimizes the setup parameters in the
[Optimize] menu for optimum measurement
results. Optimization is required whenever
you change the 'User Data Rate' and
'ENDEC' parameters.
Aborts long measurements of BER.
Checking this box will activate a track offset
compensation function. See "Track Offset
Compensation Function" on page 274.
Specifies the logging mode of the sector data.
If [ON] is selected, the number of error bytes
for each sector is counted and displayed on the
[View Sector Data]. If [OFF] is selected, the
number of error counts for a particular sector
is not counted and it deactivates the [View
Sector Data] button. Refer to the "hpe5022_
BER_berDataLoggingMode" function of the
programming manual for details.
Specifies the logging mode of the raw data. If
[All Data] is selected, all error data are logged.
Chapter 3
Advertisement
Table of Contents
