Table of Contents
Advertisement
VEE Measurement Program Operation
Measurement
NOTE
The parameter values of Channel Bit Rate, Write Current and Sense Current that have been
set in the [Configuration] menu will automatically update similar parameters in this menu.
3. Click on the [Measure] button to start measurement.
4. Click the [Return] button to return to Measure menu.
Measurement
Display
154
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Track #
The mean, minimum, maximum and standard deviation of the SNR and Crest Factor
are displayed on the upper portion of the menu. The lower portion of the menu plots the
measured SNR and Crest Factor. The upper right side of the menu shows the measured
signal and noise which are measured in terms of volt peak-to peak and volt (rms)
respectively.
Specifies the track number to be tested.
Chapter 3
Advertisement
Table of Contents
