Table of Contents
Advertisement
Figure 3-33
TAA Stability Menu
3. Set the parameters, click on each button to enter a new value.
Skip Erase & Write
Channel Bit Rate
Write Current
Sense Current
Data Pattern
# of Rev.
# of Segments
Segment #
Track#
Write Ratio
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VEE Measurement Program Operation
Selects the type of measurement sequence.
Erase and write sequences are not done when
this is checked.
Specifies the speed at which data bits are
written on the media per second [bps].
Specifies the current applied to the write head.
Specifies the current applied to the read head.
Specifies the data pattern to be selected for
measurement. To set the data pattern, click on
the [Configuration] > [Setup] > [Pattern
Config] buttons to open the data pattern menu.
Specifies the number of revolutions of
measurement.
Specifies the number segments or track
divisions.
Specifies the segment number by which to get
the results. The results of the specified
segment number will be plotted on the
window.
Specifies the track number to be tested.
Specifies the write aperture ratio relative to its
corresponding sector (segment). See "Stability
Measurement" on page 248.
Measurement
79
Advertisement
Table of Contents
