Table of Contents
Advertisement
E5011A HLM Stage
During power on the spinstand, do not stick your fingers near the HLM Stage in the
following precautionary area.
Figure 1-7
Precautionary Area
NOTE
Although there is no shroud in Figure 1-7, do not remove it in use.
Shroud (Spindle Cover)
While the spindle is running, DO NOT stick your fingers in the shroud.
The spindle will not rotate if the shroud is open. This is designed to provide safety during
work, therefore DO NOT remove the shroud.
Emergency Switch
In the event of an emergency push the emergency switch button (red button on the front
panel of the spinstand), this will immediately stop the spindle rotation and HLM- Spindle
stage movement. To reset this switch, slowly turn it clockwise until it pops up.
Chapter 1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Introduction
Safety Precautions
29
Advertisement
Table of Contents
