Table of Contents
Advertisement
Radius 1
Radius 2
Skew 1
Skew 2
The upper portion of the window shows the pivot to center, pivot to gap,
radius1/radius2, and skew1/skew2.
[Speed On Ramp] and [Advanced...] buttons on the "Ramp Load" frame are available
when the Ramp load is specified as the Load Type.
Speed On Ramp
Click on [Advanced...] button on the "Ramp Load" frame to set the initial radius, initial
skew and disk size restriction.
Figure 4-18
Advanced Ramp Load Config Menu
Init Radius
Init Skew
Restriction
Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Radius that can be defined optionally at any point within the data
area of the media.
Radius that can be defined optionally at any point within the data
area of the media.
Specifies the head skew angle relative to Radius 1.
Specifies the head skew angle relative to Radius 2.
Specifies the head speed between the ramp load position and the
media load position.
Specifies the radius, that the head is moved to after the head is
loaded.
Specifies the skew angle, that the head is moved to after the head is
loaded.
Selects a status of the head position restriction. This function
allows you to set the loading/unloading position and the moved
position at the outside of the media. When "On" is selected, the
head position and loading/unloading position must be inside of the
disk size. When "Off" is selected, the head position and
loading/unloading position can be set outside of the disk size.
Configuration
Configuration
235
Advertisement
Table of Contents
