Unpacking The Services Gateway; Unpacking The Srx550 Services Gateway - Juniper SRX550 Hardware Manual

CHAPTER 13

Unpacking the Services Gateway

IN THIS CHAPTER

Unpacking the SRX550 Services Gateway | 64

Verifying Parts Received with the SRX550 Services Gateway | 65
Unpacking the SRX550 Services Gateway
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
1/2 in. (13 mm) open-end or socket wrench to remove bracket bolts from the shipping pallet
Blank panels to cover any slots not occupied by a component
The SRX550 Services Gateway is shipped in a cardboard carton and secured with foam packing material.
The carton also contains an accessory box and quick start instructions.
NOTE: The services gateway is maximally protected inside the cardboard carton. Do not unpack
it until you are ready to begin installation.
To unpack the SRX550 Services Gateway:
1. Move the cardboard carton to a staging area as close to the installation site as possible, where you
have enough room to remove the components from the chassis.
2. Position the cardboard carton with the arrows pointing up.
3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the services gateway.
5. Remove the accessory box.
64