Mic With 20X1Ge Sfp Interfaces (Srx-Mic-20Ge-Sfp) - Juniper SRX5400 Manual

Power requirement
Weight
LEDs
Serial number location
Related
Documentation

MIC with 20x1GE SFP Interfaces (SRX-MIC-20GE-SFP)

Copyright © 2014, Juniper Networks, Inc.
Maximum of 570 W for the MPC with two MICs, including applicable transceivers.
NOTE:
To install and use SRX5K-MPCs in the SRX5600 and SRX5800 Services Gateways, you must
have high-capacity power supplies (either AC or DC) and high-capacity fan trays installed in
the services gateways. All models of SRX5400 Services Gateways already include high-capacity
supplies. If you do not have high-capacity power supplies and fan trays installed, the services
gateway will log an alarm condition when it recognizes the SRX5K-MPCs.
On SRX5400 and SRX5600 Services Gateways with AC power supplies, we recommend that
you use high-line (220 V) input power to ensure that the devices have adequate power to
support SRX5K-MPCs.
Approximately 10 lb (4.5 kg) without MICs
OK/FAIL LED, one bicolor:
Green–The MPC is operating normally.
Blinking green–The MPC is transitioning to online or offline.
Red–The MPC has failed and is not operating normally.
Off–The MPC is powered down.
The serial number label is yellow and is located on the opposite side of the card.
Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways on page 4
MIC with 1x100GE CFP Interface (SRX-MIC-1X100G-CFP) on page 25
MIC with 2x40GE QSFP+ Interfaces (SRX-MIC-2X40G-QSFP) on page 26
MIC with 10x10GE SFP+ Interfaces (SRX-MIC-10XG-SFPP) on page 23
MIC with 20x1GE SFP Interfaces (SRX-MIC-20GE-SFP) on page 21
You use Modular Interface Cards (MICs) and Modular Port Concentrators (MPCs) to add
different combinations of Ethernet interfaces to your services gateway to suit the specific
needs of your network.
The SRX-MIC-20GE-SFP MIC can be installed in the SRX-5K MPC (see
Figure 11 on page 22) to add twenty 1-Gigabit Ethernet small form-factor pluggable (SFP)
Ethernet ports.
MIC with 20x1GE SFP Interfaces (SRX-MIC-20GE-SFP)
21