Srx5800 Services Gateway Spc Description - Juniper SRX5800 Hardware Manual

SRX5800 Services Gateway Hardware Guide

SRX5800 Services Gateway SPC Description

Related
Documentation
16
SRX5800 Services Gateway Card Cage and Slots on page 11
SRX5800 Services Gateway Field-Replaceable Units on page 146
Each Services Processing Card (SPC) contains four Services Processing Units (SPUs),
which provide the processing power to run integrated services such as firewall, IPsec,
and IDP (see Figure 8 on page
to an SPU to have services processing applied to it. Traffic is intelligently distributed by
interface cards to SPUs for services processing.
The services gateway must have one SPC installed.
You can install an SPC in any of the slots that are not reserved for Switch Control Board
(SCB). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the device.
Figure 8 on page 16 shows a typical SPC supported on the services gateway.
Figure 8: Typical SPC
For detailed information about SPCs supported by the services gateway, see the
SRX5600, and SRX5800 Services Gateway Card Reference
SRX5800 Services Gateway Card Cage and Slots on page 11
SRX5800 Services Gateway Field-Replaceable Units on page 146
Maintaining Interface Cards and SPCs on the SRX5600 Services Gateway on page 125
Troubleshooting SRX5800 Services Gateway SPCs on page 141
16). All traffic traversing the services gateway is passed
at
Copyright © 2014, Juniper Networks, Inc.
SRX5400,
www.juniper.net/techpubs/
.