Srx5600 Services Gateway Card Cage And Slots; Srx5600 Services Gateway Spc Description - Juniper SRX5600 Hardware Manual

SRX5600 Services Gateway Card Cage and Slots

The card cage is the set of eight horizontal slots in the front of the chassis where you install cards. The
slots are numbered from bottom to top.
install into each slot.
Table 29: SRX5600 Services Gateway Card Cage Slots
Eligible Cards
Card Cage Slot SPC
5 X
4 X
3 X
2 X
1 X
0 X
1
0

SRX5600 Services Gateway SPC Description

The Services Processing Card (SPC) has Services Processing Units (SPUs), which provide the processing
power to run integrated services such as firewall, IPsec, and IDP (see
traversing the services gateway is passed to an SPU to have services processing applied to it. Traffic is
intelligently distributed by interface cards to SPUs for services processing.
The services gateway must have one SPC installed.
You can install an SPC in any of the slots that are not reserved for Switch Control Board (SCB). If a slot is
not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to
circulate properly through the device.
Figure 42 on page 99 shows a typical SPC supported on the services gateway.
Table 29 on page 98
MPC IOC
X X
X X
X X
X X
X X
X X
describes the types of cards that you can
Flex IOC
X
X
X
X
X
X
Figure 42 on page
98
SCB
X
X
99). All traffic