Server Card Installation - Avaya 1000 Installation And Commissioning Manual

MG 1000B platform hardware installation
Installing the Gateway Controller card
1. Insert the Gateway Controller into Slot 0 of the Media Gateway.
Important:
Please DESTROY or RETURN the SSC dongle to your local Avaya Repairs/Returns
center upon confirmation of a successful upgrade. If the SSC system was using remote
dongles for any expansion cabinets, please DESTROY or RETURN to your local Avaya
Repairs/Returns center upon confirmation of a successful upgrade.
Note:
If the upgrade fails, you will not be able to revert back to the old system without the SSC
card and dongle.
For the CP PM call server, you must use the dongle provided with the software kit. Chassis
Expander dongles may be disposed of, as they are no longer needed.
2. Connect the serial cable.
• For the MG 1000E, connect the 3-port SDI cable (NTBK48AA) to the SDI0 port on the
Media Gateway. Connect the opposite end of the cable to a maintenance terminal.
• For the MG 1010, connect a shielded CAT5 Ethernet cable to the NTC325AAE6 serial
cable kit. Connect this cable to the MGU faceplate port labelled TTY0 in the Media
Gateway. Connect the opposite end of the cable to a maintenance terminal.
3. Power on the Media Gateway.
• The Gateway Controller display shows BOOT.
• The power on self-test runs. The Gateway Controller display shows POST.
• The Gateway Controller display shows PASS if the self-test is successful. Otherwise the
Gateway Controller display shows an Exxx error code.
• The Gateway Controller loads the application software. The Gateway Controller display
shows LOAD.

Server card installation

The following procedures describes how to install a Server card in a Media Gateway.
MG 1010 slots 22 and 23 require the metal faceplate NTDW53 CP DC card or NTDW99 CP PM
card. If you require more than two Server cards in a MG 1010, you can install the additional Server
cards in slots 1-10. MG 1000E and MG 1010 slots 1-10 support NTDW53 CP DC cards, NTDW61,
and NTDW99 CP PM cards.
Ensure that the Dip Switch (S5) is set to position 1 if using the CP PM as a Call Server or position 2
if using the card as a CP PM Signaling Server.
Installing the CP PM or CP DC card
1. Ensure that the security dongle (the one that comes as part of the software kit) is inserted on
the Server card.
Branch Office Installation and Commissioning
124
Comments? infodev@avaya.com
June 2014