Branch User Config Command - Avaya 1000 Installation And Commissioning Manual

MG 1000B telephones
Figure 63: Set-Based Installation Step 1
2. Enter the TN and press the OK soft key, as shown in
2 on page 164.
Figure 64: Set-Based Installation Step 2
3. Replace the handset when you hear a relocation tone and see OK on the screen display.
4. The IP Phone is now registered with the Call Server. Wait approximately ten seconds for the
key map download to complete. The IP Phone is now fully operational in Local Mode. The
screen appears as shown in
Figure 65: Set-Based Installation complete
5. Test for survival functionality by making and receiving a call on the telephone.
6. The telephone is now configured for basic operation and survivability. To configure the
Branch User, see
You must also configure the Set-Based Removal feature prompts SRCD (LD 15) and AREM (LD 57)
by following Setting and changing the Station Control Password Configuration

Branch User Config command

To complete the interface-based configuration of the Branch User, the administrator or a trusted
user can configure the IP Phone with the Branch User Config command. Before proceeding, be sure
to obtain the required passwords as described in
Branch Office Installation and Commissioning
164
Figure 65: Set-Based Installation complete
Branch User Config command
Comments? infodev@avaya.com
Figure 64: Set-Based Installation Step
on page 164.
Password requirements
on page 164.
on page 110.
on page 162.
June 2014