Table of Contents
Advertisement
2. Connect the other end of the power cable to the AC power.
3. Use a serial cable to connect a PC to the device's serial port. This connection is required for
4. Connect a network cable to the NIC1 Ethernet connector on the rear panel (see
Configuring the IP Address for the Avaya Scopia
Application server
The Avaya Scopia
To configure a static IP, navigate to the Network and Sharing Center under Windows Control Panel.
For more information, refer to the relevant documentation from Windows.
Verifying the Server Installation
About this task
After you installed the device and performed its initial configuration, you need to verify that it is installed
and configured correctly.
Installation Guide for Avaya Scopia
Figure 16: Rear panel of the device
local configuration and maintenance.
Important:
Do not connect a screen or a keyboard to the device directly. Define the device's basic
settings via the serial connection only.
16: Rear panel of the device
Use both Ethernet connectors for dual-NIC deployments. A dual-NIC deployment raises
security by using different subnets for media versus management. Use NIC1 Ethernet
connector for management and the NIC2 connector for media.
®
Application server comes preconfigured with an automatic IP (DHCP) address.
®
Application Server Version 2
on page 20).
Figure
®
Setting up the Device | 20
Advertisement
Table of Contents
