Avaya 1000 Installation And Commissioning Manual page 117

Figure 25: Right ear bracket on an MG 1000B
4. Attach the left ear bracket (marked with an "L") to the holes on the left side of the MG 1000B
(near the front).
a. Use two #8-32 machine screws. Position the ear bracket so the four holes on the
bracket flange are closer to the rear of the Media Gateway 1000.
Note:
To determine the front of the bracket, locate the "L" on the bracket. The "L" must be
at the top of the bracket and face the front of the MG 1000B.
Warning:
An MG 1000B or an MG 1000B Chassis Expander weighs approximately 30 lb. (13.5 kg)
with circuit cards installed and 26 lb. (12 kg) without circuit cards installed. If necessary,
get assistance when lifting the equipment.
5. Place the MG 1000B on the guide brackets.
a. Carefully slide the MG 1000B into the rack until the ear brackets come to rest against
the rack support.
Note:
Make sure that the rear of the MG 1000B is on the guide brackets.
6. Use the four remaining #10-32 machine screws to fasten the MG 1000B to the rack supports
(two screws on each side). See
June 2014
Figure 26: MG 1000B installed in a rack
Branch Office Installation and Commissioning
Comments? infodev@avaya.com
Installing an MG 1000B Core
on page 118.
117