Installing An Ip Phone Using The Keypad - Avaya 1000 Installation And Commissioning Manual

Installing an IP Phone using the keypad

Before proceeding to install an IP Phone using the keypad, be sure to obtain the required
passwords, as described in
The procedure to install an IP Phone through the telephone interface consists of three steps.
1. Connect the IP Phone to an Ethernet jack and configure the S1 IP address (or use Dynamic
Host Control Protocol (DHCP) to retrieve the IP address).
The S1 IP address is the IP address of the MG 1000B TPS. If it is entered as the main office
TPS, the IP Phones register to the main office, but do not behave as MG 1000B IP Phones.
2. Configure the Branch User ID (BUID) and its Main Office TN (MOTN) through
Branch User
These three steps are easily performed and enable an administrator to install and provision a
telephone.
Warning:
After all IP Phones have been installed, perform a datadump (using LD 43 EDD or NRS
Manager) on the MG 1000B Call Server. Refer to Avaya Communication Server 1000E:
Installation and Configuration (NN43041-310).
If you have already unpacked and connected the IP Phone, complete
Installation on page 163. It simplifies configuration of MG 1000B IP Phones for survivability. Each
MG 1000B IP Phone must also be provisioned at the main office.
To use DHCP addressing (using the automatic installation procedure, see Avaya Communication
Server 1000E: Installation and Configuration (NN43041-310) for more information ), and verify that
the network has DHCP enabled.
The IP Phone screen display differs according to the telephone model in use. For example, the
screen displays shown in the procedures in this section are for an IP Phone 2004. The IP Phone
2001 and IP Phone 2002 have a one-line display. The IP Phone 2004, Avaya 2007 IP Deskphone
and Avaya 2050 IP SoftPhone have a three-line display. Users can scroll through the display
screens using the navigation keys.
Using Set-Based Installation
This procedure installs IP Phones at the Branch Office and Main Office. If necessary, the
administrator can perform an installation when the Branch User is in Local Mode.
1. To configure the S1 (primary connect server) on the IP Phone, choose DHCP, or manually
enter the IP address of the local (MG 1000B) TPS node. Enter the Branch Office node
number and password, as shown in
June 2014
Password requirements
on page 166.
Comments? infodev@avaya.com
Installing an IP Phone using the keypad
on page 162.
Figure 63: Set-Based Installation Step 1
Branch Office Installation and Commissioning
Configuring a
Using Set-Based
on page 164.
163