MG 1000B platform hardware installation
Important:
Observe proper ESD precautions while handling the hard drive and CP PM Signaling Server.
Use the following procedure to replace the hard drive on a CP PM Signaling Server.
Replacing the hard drive on a CP PM Signaling Server
1. Ensure jumper is located in the cable select (CS) position according to the labeling on the
hard drive.
Figure 45: CP PM hard drive jumper
2. Place hard drive on printed circuit board and slide to mate with connector J32.
Figure 46: CP PM hard drive and connector J32
3. Secure hard drive from the bottom side with the included screws.
Branch Office Installation and Commissioning
138
Comments? infodev@avaya.com
June 2014