Avaya 1000 Installation And Commissioning Manual page 187

Prompt
- RLI
...
- SDRR
- - DMI
Important:
The Branch Office must recognize incoming digits on the Virtual Trunk and remove
all but the ESDN.
7. Test ESDN using a main office telephone to confirm that main office calls go out the main
office trunks.
If OSDN is used, the ESA route number must be blank to make test calls without using any
trunk resources. It the route number has been configured, remove it by entering "x" at the
prompt.
Configuring the Branch Office
You can use Element Manager or the Command Line Interface for this procedure. Refer to Avaya IP
Peer Networking Installation and Commissioning, NN43001-313.
1. Configure an emergency trunk (CAMA or PRI).
2. Configure the Virtual Trunk.
Before a call can come in on the Virtual Trunk, the Virtual Trunk must be configured.
3. Configure ESN.
June 2014
Response Description
Route List Index to be accessed
0-127 CDP and BARS
0-255 NARS
0-1999 FNP
Supplemental Digit Restriction or Recognition
ALOW Allowed codes
ARRN Alternate Routing Remote Number
DDD Recognized remote Direct Distance Dial codes
DENY Restricted codes
DID Recognized remote Direct Inward Dial codes
ITED Incoming Trunk group Exclusion Digits
LDDD Recognized Local Direct Distance Dial codes
LDID Recognized Local Direct Inward Dial codes
STRK For ADM/MDM trunk groups
<cr> Return to SPN
1-255 Digit Manipulation Index
1-1999 Digit Manipulation Index with FNP
DMI is only prompted when the Directory Number
Expansion (DNXP) package 150 is equipped and
SDRR = LDID.
Branch Office Installation and Commissioning
Comments? infodev@avaya.com
Emergency Services Access (ESA)
187