Using The Ip Phones; Changing The Scpw; Telephone Options - Avaya 1000 Installation And Commissioning Manual

Warning:
After all telephones are installed, perform a datadump (using LD 43 or NRS Manager) on
the MG 1000B Call Server. Refer to Avaya Communication Server 1000E: Installation
and Configuration (NN43041-310) for more information.
6. Test the IP Phones for survivability using

Using the IP Phones

An MG 1000B IP Phone is operational immediately after configuration. You can learn more about its
services by referring to
Fundamentals, NN43001-368. You can also test the telephone. Refer to
page 177.

Changing the SCPW

Use Installing IP Phones through overlays
time.
Changing the SCPW
1. Dial the SCPC code followed by the current Station Control Password.
An FFC tone is given at this point.
2. Enter the new password.
The new password must be the same length as SCPL.
3. Wait for the FFC tone and enter the new password again.
If the new password is accepted, another FFC tone is given. If the new password is not
accepted, an overflow tone is given.

Telephone Options

The IP Phone Options feature is described in Avaya IP Deskphones Fundamentals, NN43001-368.
Using the Telephone Options feature
This procedure explains how to use IP Phone Options features. The IP Phone has been configured
using Branch User Config and is operating in Normal Mode.
1. Press the Services key (the key with the Globe icon).
The Options menu is displayed (see
June 2014
Telephone Options on page 173 and to Avaya IP Deskphones
on page 171 to change the SCPW of a telephone at any
Figure 73: Options menu
Comments? infodev@avaya.com
Testing the telephone for survivability
on page 174).
Branch Office Installation and Commissioning
Using the IP Phones
on page 170.
Test Local Mode on
173