Avaya 1000 Installation And Commissioning Manual page 126

MG 1000B platform hardware installation
Figure 31: SDI cable
The preceding steps enable users to upgrade the system one MG 1000B at a time. For each
additional Media Gateway, repeat
CP DC card on page 124.
The following procedure describes how to install and connect a CP MG card as a Server. Perform
the following procedure to install the CP MG card into a Media Gateway cabinet or chassis.
Note:
The CP MG card functions as a Gateway Controller and a Server while occupying one slot in a
Media Gateway. You require different cables to connect to each component of a CP MG card.
Installing the CP MG card
1. Ensure that the security dongle is inserted on the CP MG card.
2. Insert and slide the CP MG card into Slot 0 of a Media Gateway cabinet or chassis.
3. Lock the card in place with the faceplate latches.
4. Connect the serial cable:
Note:
The NTC325AAE6 serial port adapter kit is required.
• Connect a Cat5e or Cat6 Ethernet cable to the TTY1 port on the CP MG faceplate.
• Connect a NTC325AAE6 serial port adapter (9 pin or 25 pin) to the other end of the
Ethernet cable.
• Connect the Ethernet cable with serial port adapter to the serial port of a maintenance
terminal.
Branch Office Installation and Commissioning
126
Removing the SSC card
Comments? infodev@avaya.com
on page 121 to Installing the CP PM or
June 2014