Avaya 1000 Installation And Commissioning Manual page 165

If the Branch User ID (BUID) is not configured, the IP Phone registers at the MG 1000B CP PM and
stays in Local Mode. If the IP Phone is configured with a BUID, it is automatically redirected to the
main office TPS and then to the main office Call Server. If there is a BUID, the MOTN is equal to the
set TN by default. If there is no BUID MOTN, it has not yet been configured. A BUID is used for
redirection, while the MOTN is used on the main office for registration. Redirection may not be
successful (refer to
Branch User Config is the IP Phone-based mechanism to enter the BUID so that the IP Phone can
be redirected to the main office to run in Normal Mode. Branch User Config is an option on the
Options menu display that is available to the Branch User.
The menu option for Branch User Config is shown in
Figure 66: Options menu
If an SCPW has been configured, "Password Admin" appears in the list as the second option,
forcing the "Branch User Config" option to scroll out of sight. Use the navigation keys to scroll down
to "Branch User Config".
To register an IP Phone to the main office, Branch User Config uses the following:
• Branch User ID (BUID)
• Branch password — IP Phone Installer's Password or Temporary IP Phone Installer's
Password
• Main Office TN (MOTN), in l s c u. This defaults to the TN at the MG 1000B.
• Main office password — IP Phone Installer's Password, Temporary IP Phone Installer's
Password, or SCPW.
For information on setting up passwords, see
Branch User Config is used for configuration. Once the IP Phone is configured at the Branch Office,
its parameters redirect the IP Phone to the main office. This means that configuration is not required
a second time unless the Branch User parameters change on that IP Phone.
Attempting to perform a Branch User Config to a TN of a different set type at the main office results
in a Permission Denied (4) error message on the display of the IP Phone. See
Operation troubleshooting
Whenever a valid change is made to BUID/MOTN in LD 11, the IP Phone, if in Local Mode, is
automatically redirected to the main office. A service change to BUID/MOTN does not affect IP
June 2014
Table 33: Normal Operation troubleshooting
on page 196 for more information on error messages.
Comments? infodev@avaya.com
on page 196).
Figure 66: Options menu
IP Phone passwords and parameters
Branch Office Installation and Commissioning
Branch User Config command
on page 165.
on page 109.
Table 33: Normal
165