Maintenance and diagnostics
Message
Signaling Server CLI commands
This section describes Command Line Interface (CLI) commands on the Signaling Server specific to
the MG 1000B.
Refer to Avaya Signaling Server IP Line Applications Fundamentals, NN43001-125 for a complete
list of all CLI commands available on the Signaling Server.
isetShow
The isetShow command shows the type of IP Phone registration and the registration status. This
command displays general information for all registered IP Phones.
clearLockout TN or IP
A registration lock is placed at the TPS after three consecutive failed attempts to enter either the IP
Phone Installer's Password or the Temporary IP Phone Installer's Password.
The lockout affects the Virtual Office login or Branch User Config and lasts for one hour. This
lockout does not survive re-registration of the IP Phone. However, the installation technician can
issue the clearLockout command to clear the lockout for a particular telephone.
This command has one parameter, the TN or IP address of the telephone.
Call Server commands
This section contains LD commands on the Call Server applicable to the Branch Office feature.
Branch Office Installation and Commissioning
200
Probable Cause
Link to main office TPS is
down.
Main office Call Server is
down.
Main office node is not
registered as a SIP or H.323
endpoint to the NRS.
Comments? infodev@avaya.com
Actions
Restore link to main office TPS.
Bring main office Call Server into service.
Register the main office node to the NRS.
June 2014