Avaya 1000 Installation And Commissioning Manual page 116

MG 1000B platform hardware installation
Figure 24: Guide bracket installed in a rack
The guide brackets guide the MG 1000B into place and enable one person to install the MG
1000B in the rack.
2. Fasten the left guide bracket to the left rack support.
a. Insert two #10-32 machine screws into the two middle slots in the bracket and into the
respective holes in the left rack support.
b. Fasten the screws.
3. Attach the right ear bracket (marked with an "R") to the holes on the right side of the MG
1000B. See
a. Use two #8-32 machine screws. Position the ear bracket so that the four holes on the
bracket flange are nearer to the rear of the MG 1000B.
Note:
To determine the front of the bracket, locate the "R" on the bracket. The "R" must
be at the top of the bracket and face the front of the MG 1000B (see
Right ear bracket on an MG 1000B
b. Position the ear bracket so that the four holes on the bracket flange are nearer to the
back of the MG 1000B. To determine the front of the bracket, locate the "R". This "R"
must be at the top of the bracket and must face to the front of the MG 1000B.
Branch Office Installation and Commissioning
116
Figure 25: Right ear bracket on an MG 1000B
Comments? infodev@avaya.com
on page 117.
on page 117).
Figure 25:
June 2014