Chapter 13: Branch Office configuration
Contents
This chapter contains the following topics:
Configuring the Branch Office
Adding the Branch Office endpoints to the NRS database
Configuring the Branch Office
After connecting the MG 1000B Core to the network and configuring the system user names and
passwords (see
MG 1000B software installation
Summary of steps
Perform the following steps to configure a Branch Office:
1. Configure the ELAN network interface IP address (see
the network
2. Configure the ZBD (optional) (see
3. Configure the Voice Gateway Media Cards (see
Cards
on page 159).
4. Configure trunks and lines (see
5. Configure IP Phones (see
6. Configure ZFDP (optional)
7. Configure Dial Plan (private if DIALPLAN option is set to PRV in CDB, or public if
DIALPLAN option is set to PUB).
Branch Office Installation and Commissioning
158
on page 158
on page 142).
Configuring the Zone Based Dialing
Configuring the trunks and lines
Installing and configuring IP Phones
Comments? infodev@avaya.com
on page 160
on page 140), complete the configuration.
Connecting the MG 1000B Core to
Configuring the Voice Gateway Media
on page 161).
on page 159).
on page 160).
June 2014