Avaya 1000 Installation And Commissioning Manual page 110

Main office configuration
Table 10: IP Phone node passwords
Command
nodePwdSet
nodePwdShow
nodePwdEnable
nodePwdDisable
nodeTempPwdClear
nodeTempPwdSet
For detailed command-line or Element Manager procedures, refer to Avaya Signaling Server
IP Line Applications Fundamentals, NN43001-125.
To use the Virtual Office feature, a Station Control Password (SCPW) must be configured at both
the Branch Office and the Main Office. This procedure enables you to configure the length of the
SCPW and the parameters for telephone modification. The actual SCPW password configuration
takes place while configuring the telephone data through the overlays. Telephone data is discussed
in MG 1000B telephones
The SCPW is also used to access the user's Personal Directory, Callers List, and Redial List. The
user can configure a second SCPW solely for this purpose if desired. If the user chooses to use the
same SCPW for all applications, the SCPW must be the same at both the main office and Branch
Office.
Setting and changing the Station Control Password Configuration
The following steps are used to configure the SCPW.
1. Configure the length of the password, SCPL, to be of non-zero length in LD 15.
Table 11: LD 15 Configure the SCPW length in the Customer Data Block.
Prompt
REQ:
TYPE:
SCPL
2. Assign the Automatic Set Relocation security code.
Table 12: LD 15 Assign Automatic Set Relocation security code.
Prompt
REQ:
TYPE:
CUST
Branch Office Installation and Commissioning
110
Description
Sets the node password. If a non-zero length password is configured,
all IP Phones that attempt to register after this command is entered
display a prompt for node password before the TN can be modified.
Shows the node password settings.
Enables node password checking.
Disables node password checking.
Deletes the temporary password and resets its uses and time to zero.
Sets the node-level TN entry temporary password.
on page 161.
Response
CHG
FFC
0-8
Response
CHG
FTR
0-99
Comments? infodev@avaya.com
Description
Change existing data.
Flexible Feature Code
Length of SCPW, minimum recommended is 4 digits
Description
Change existing data.
Customer Features and options
Customer number
Range for CSLS; and CS1000E; system
June 2014