Avaya 1000 Installation And Commissioning Manual page 136

MG 1000B platform hardware installation
b. Route the Ethernet patch cable through the hole you made in the back panel of the
UEM.
c. Plug the other end of the Ethernet patch cable into the remaining Ethernet port coupler
mounted in the Ethernet port adapter plate.
d. Label the Ethernet port coupler as TLAN.
See the following figures.
Figure 41: TLAN connection on faceplate
Figure 42: TLAN connection on Ethernet port coupler
10. Fit the Ethernet port adapter plate into the hole on the back of the UEM and tighten the
screws.
Branch Office Installation and Commissioning
136
Comments? infodev@avaya.com
June 2014