Avaya 1000 Installation And Commissioning Manual page 134

MG 1000B platform hardware installation
Figure 37: J2-J5 plates on back panel of UEM
7. Knock out the metal plate from selected J2-J5 location.
See the following figure.
Figure 38: Selected J2-J5 plate on back panel of UEM
This provides a hole through which the Ethernet patch cables are routed, and to which the
Ethernet port adapter plate is attached.
8. Establish an ELAN port on the back panel of the UEM.
a. Insert the end of one of the RJ-45 CAT5 Ethernet patch cables (supplied) into the ELAN
network interface (ELAN port) on the faceplate of the server.
Branch Office Installation and Commissioning
134
Comments? infodev@avaya.com
June 2014