Upgrading The Cp Pm Software - Avaya 1000 Installation And Commissioning Manual

Note:
If you require a longer cable to reach your maintenance terminal, you can attach a
standard serial port cable to the adapter for extended cable length.
5. Configure the maintenance terminal for VT-100 emulation, 9600 bps, 8-N-1.
6. Connect the ELAN cable:
• Connect one end of a shielded Cat5e or Cat6 Ethernet cable to the 1E (ELAN) port on the
CP MG faceplate.
• Connect the other end of the cable to the ELAN subnet of the system.
7. Connect the TLAN cable:
• Connect one end of a shielded Cat53 or Cat6 Ethernet cable to the 2T (TLAN) port on the
CP MG faceplate.
• Connect the other end of the cable to the TLAN subnet of the system.
8. Power on the CP MG card.
To connect and configure a CP MG card as a Gateway Controller, the 3-port SDI cable
(NTBK48AA) is required. The NTBK48AA cable connects to the SDI port on the Media Gateway
cabinet or chassis and provides serial port access to the Gateway Controller portion of the CP MG
card.

Upgrading the CP PM software

Note:
The CP PM version 1 hardware (NTDW61 and NTDW99BAE6) must run BIOS Release 18 or
later to support the Linux base Operating System. The CP PM version 2 (NTDW99CAE6) meets
the requirements for Linux base. CP PM version 2 includes an updated hardware design, BIOS,
and boot manager.
1. Check that a terminal is connected to COM 1 port in CP 1. The settings for the terminal are:
• Terminal type: VT100
• 9600 Baud
• Data bits: 8
• Parity: none
• Stop bits: 1
• Flow control: none
2. Insert the RMD into the CF card slot on the active core.
3. Press the manual RESET button on the CP PM card faceplate.
4. The CP PM card reboots. Press F when prompted to boot from the faceplate Compact Flash
card containing the installation software.
June 2014 Branch Office Installation and Commissioning
Comments? infodev@avaya.com
Upgrading the MG 1000B hardware
127