Avaya 1000 Installation And Commissioning Manual page 166

MG 1000B telephones
Phones in Normal Mode. If the BUID of an IP Phone is deleted in a service change, no attempt is
made to redirect the telephone to the main office.
Warning:
Do not delete the BUID/MOTN. If they are subsequently deleted, the association between the
main office and the Branch Office is lost, and any IP Phones which are in, or go into, Local
Mode, remain in Local Mode.
Configuring a Branch User
1. To invoke the login and configuration operation for a Branch User, press the Services key
(the key with the Globe icon) on an idle IP Phone. If the Branch Office package is equipped,
the Branch User Config options are displayed.
2. Select Branch User Config, as shown in
3. Enter the Branch User ID; that is a dialable DN of the main office. See
User ID on page 166.
For a CDP dialing plan, the Access Code is not required; for example, xxx-xxxx. For a UDP
dialing plan, this DN includes the Access Code; for example, 6-xxx-xxxx.
Figure 67: Branch User ID
4. Enter the branch password; that is, the IP Phone Installer's Password or Temporary IP
Phone Installer's Password for the TPS node at the Branch Office. See
password on page 166.
Figure 68: Branch password
Branch Office Installation and Commissioning
166
Figure 66: Options menu
Comments? infodev@avaya.com
on page 165.
Figure 67: Branch
Figure 68: Branch
June 2014