Co-Resident Call Server And Signaling Server Software Installation; Preinstallation Checklist - Avaya 1000 Installation And Commissioning Manual

MG 1000B software installation
Co-resident Call Server and Signaling Server software
installation
The Co-resident Call Server and Signaling Server (Co-res CS and SS) is supported on various
hardware. For more information, see Avaya Co-resident Call Server and Signaling Server
Fundamentals, NN43001-509.
The CP PM hardware platform must be equipped with a 40 GB hard disk and 2 GB memory to
support the Co-res CS and SS configuration. The CP PM version 1 hardware (NTDW61 and
NTDW99BAE6) must run BIOS Release 18 or later to support Co-res CS and SS. The CP PM
version 2 (NTDW99CAE6) meets the requirements for Co-res CS and SS. CP PM version 2
includes an updated hardware design, BIOS, and boot manager. For more information about the
methods for ensuring the CP PM hardware meets the above requirements, see Avaya Co-resident
Call Server and Signaling Server Fundamentals, NN43001-509.
The installation of a Co-res CS and SS consists of two parts:
• Linux Base installation
• Linux application installation
Two separate installation media are provided: one contains the Linux Base image and the second
contains all the Co-resident Call Server, Signaling Server, and system management application
software.
For more information about Avaya Linux Base installation, see Avaya Linux Platform Base and
Applications Installation and Commissioning, NN43001-315 .
Caution:
LOSS OF DATA
Branch Office CP PM based VXWorks systems do not require a BIOS upgrade.

Preinstallation checklist

The CP PM Co-res CS and SS requires a CP PM hardware platform with a 40 GB hard drive and 2
GB of memory. The CP PM version 1 hardware (NTDW61 and NTDW99BAE6) must run BIOS
Release 18 or later to support Co-res CS and SS. The CP PM version 2 (NTDW99CAE6) meets the
requirements for Co-res CS and SS.
You must perform the following procedures before any installation to ensure CP PM hardware meet
the preceding requirements.
Note:
The Call Server LD 135 stat mem command on a CP PM Co-res CS and SS does not show
the actual physical memory size on the CP PM hardware. It displays the amount of memory that
the Call Server application uses.
Determining CP PM BIOS Method 1
1. Power up the CP PM hardware.
Branch Office Installation and Commissioning
150
Comments? infodev@avaya.com
June 2014