Perform A Customer Backup Data Dump (Installation Release) - Avaya 1000 Installation And Commissioning Manual

MG 1000B platform hardware installation
• Power down the Media Gateway.
• Remove the SSC card.
• Destroy or return the SSC security device to your local Avaya Repairs/ Returns center.
• If using a card as the Gateway Controller, Install the DSP Daughterboard on the card as
described in Installing a DSP Daughterboard
• Install the Gateway Controller as described in
page 124.
• Install the Server as described in
• Cable the cards as shown in
• Power up the MG 1000B.
• Enter the 'setup' menu and configure the IP parameters, then reboot the Gateway Controller.
If the Centralized Software Upgrade (CSU) feature is enabled on the Call Server, the firmware for
the Gateway Controller is downloaded automatically (or if the internal Compact Flash is blank),
otherwise initiate the firmware download using Overlay 143 commands.

Perform a customer backup data dump (installation release)

1. Log in to the system.
2. Insert a Removable Media Device (RMD) into the active Server RMD slot to back up the
database.
3. Load the Equipment Data Dump Program (LD 43). At the prompt, enter
Table 17: LD 43 – Load program
LD 43
.
4. When EDD000 appears on the terminal, enter:
Table 18: Begin the data dump
EDD
Caution:
Service Interruption
Loss of Data
If the data dump is not successful, do not continue; contact your technical support
organization. A data dump problem must be corrected before proceeding.
5. When DATADUMP COMPLETE and DATABASE BACKUP COMPLETE appear on the
terminal, enter:
Branch Office Installation and Commissioning
120
on page 122.
Installing the Gateway Controller card
Installing the CP PM or CP DC card
Gateway Controller network connections
Load program.
EDD
Begin the data dump.
Comments? infodev@avaya.com
on
on page 124.
on page 47.
June 2014