Chapter 8: Testing the media server installation
This chapter provides tests for the control network, including
reviewing the status of the configuration.
●
testing the duplication link to the media servers
●
testing the IPSI circuit packs.
●
In addition, it provides information on the LED status indicators for the media servers, Avaya
Ethernet switch(es), uninterruptible power supplies (UPSs), and different circuit packs. See
indicators
on page 85.
Note:
Circuit pack positions are usually given by cabinet, and slot. They may also be
Note:
given by port. The term cabinet refers to five G650 Media Gateway TDM-cabled
together in a rack, making up one port network. A port network is defined as a
group of media gateways connected together with one TDM bus.
Perform these tasks to test the configuration:
!
CAUTION:
To prevent unnecessary trouble tickets, do not enable the alarms (Alarm
CAUTION:
Origination feature) until all installation and administration procedures are
completed.
Testing the TN2312BP IPSI circuit pack
●
Testing the license file
●
Testing the media server LEDs
●
Testing the TN2312BP IPSI circuit pack
Note:
Do these steps using a SAT session
Note:
Note:
For SAT commands you must be on the active media server.
Note:
These steps test the TN2312BP IPSI circuit pack.
1. Type test ipserver-interface UUC and press Enter to test all clock and packet
interface components within the IPSI circuit pack.
on page 83
on page 84
on page 86
LED
Issue 4.1 June 2005
83