Configuring The Zone Based Dialing; Configuring The Voice Gateway Media Cards - Avaya 1000 Installation And Commissioning Manual

Configuring the Zone Based Dialing

To configure zone based parameters, the Zone Based Dialing (ZBD) option is activated using LD
15. After it is set to YES, the DIALPLAN prompt is shown and the user can select public or private
on-net dial plan.
Table 24: New prompts for LD 15
Prompt
REQ:
TYPE:
VO_CUR_ZONE_TD
ZBD
The following procedure demonstrates a basic overview of the steps to follow to configure the ZBD.
For more information on the ZBD, see Avaya Dialing Plans Reference, NN43001-283.
1. Enable the Zone Based Dialing option in LD 15.
2. Set the dial plan option to the appropriate dial plan PUB or PRV.
3. Configure the numbering zones from LD 117.
4. Configure numbering zone parameters.
5. Configure CLID entries for a key of a telephone.
6. Configure sets with numbering zones and appropriate CLIDs.
Important:
The DN of a telephone should be 7 digits: PREF + shortDN.
PREF refers the prefix for a Dialed Number (DN); for example, in the following DN, 838-5775, 838
equals PREF.

Configuring the Voice Gateway Media Cards

The Voice Gateway Media Cards (see
a customer location with pre-installed software. To install and upgrade these cards, you need the
latest workfile. The workfile is delivered by the PC card or Element Manager and contains all Voice
Gateway Media Card operating system and application files. The workfile is a single packed and
compressed file.
For more information on configuring the Voice Gateway Media Card, see Avaya Signaling Server IP
Line Applications Fundamentals, NN43001-125
June 2014
Response
CHG
FTR_DATA
(NO) YES
(NO) YES
Figure 28: Voice Gateway Media Card
Comments? infodev@avaya.com
Configuring the Zone Based Dialing
Comment
Change existing data block
Customer Features and options
ZBD option
Branch Office Installation and Commissioning
on page 119) arrive at
159